Installation [11/2017 - ]: Procedure

INSTALL REAR SPEED SENSOR

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the rear speed sensor with the nut.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE:
  Make sure that the sensor tip is clean.
2. Connect the speed sensor connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to PRECAUTION [08/2015 - ]
CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)
Refer to TEST MODE PROCEDURE [11/2017 - ]
CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)
Refer to TEST MODE PROCEDURE [11/2017 - 09/2019] , or refer to TEST MODE PROCEDURE [09/2019 - ]