Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2021 >> Tacoma TRD Pro, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Multi-Terrain Select Switch >> Inspection [08/2015 - ] >> Procedure

Inspection [08/2015 - ]: Procedure

  1. INSPECT MULTI-TERRAIN SELECT SWITCH (DRIVE MONITOR SWITCH) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY694352Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        TEXT IN ILLUSTRATION

        *1 Multi-terrain Select Switch
        *a MUD and SAND
        *b LOOSE ROCK
        *c MOGUL
        *d ROCK and DIRT
        *e ROCK
        GTY569005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Multi-terrain Select Switch (Drive Monitor Switch))

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        7 (ECU) - 8 (E) MUD and SAND Below 1 Ω
        2 (UP) - 8 (E)
        6 (DN) - 8 (E) 10 kΩ or higher
        7 (ECU) - 8 (E) LOOSE ROCK Below 1 Ω
        2 (UP) - 8 (E) 10 kΩ or higher
        6 (DN) - 8 (E)
        7 (ECU) -8 (E) MOGUL 10 kΩ or higher
        2 (UP) -8 (E)
        6 (DN) -8 (E)
        7 (ECU) - 8 (E) ROCK and DIRT 10 kΩ or higher
        2 (UP) - 8 (E)
        6 (DN) - 8 (E) Below 1 Ω
        7 (ECU) - 8 (E) ROCK 10 kΩ or higher
        2 (UP) - 8 (E) Below 1 Ω
        6 (DN) - 8 (E)
        1 (SWl1) - 8 (E) ON/OFF: Pressed Below 1 Ω
        ON/OFF: Not pressed 10 kΩ or higher

        If the result is not as specified, replace the multi-terrain select switch (drive monitor switch).

scientia non olet · About Mike's Workshop Manuals