Removal [11/2017 - ]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [08/2015 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [11/2017 - 09/2019] , or refer to INITIALIZATION [09/2019 - ]
- REMOVE FRONT WHEEL
- REMOVE FRONT SPEED SENSOR
- Disconnect the speed sensor connector.
- Remove the bolt and front speed sensor.NOTE:
- Do not attach any foreign matter to the sensor tip.
- Ensure that no foreign matter enters the sensor installation part.