On-Vehicle Inspection [11/2015 - ]: Procedure
- INSPECT MASS AIR FLOW METER SUB-ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.
Powertrain > Engine > Data List
Tester Display Mass Air Flow Sensor - Blow air into the mass air flow meter sub-assembly and check that the value of Mass Air Flow Sensor fluctuates.
OK
The value changes.
If the result is not as specified, clean the mass air flow meter sub-assembly.
Air Refer to INSPECTION [11/2015 - ]