Inspection [11/2015 - ]: Procedure
- INSPECT HEATED OXYGEN SENSOR
*a Component without harness connected
(Heated Oxygen Sensor)- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Click Location & Routing(C9)
Click Connector(C9)
Tester Connection Condition Specified Condition C9-1 (HT1B) - C9-2 (+B) 20°C (68°F) 5 to 10 Ω C9-1 (HT1B) - C9-4 (E2) Always 10 kΩ or higher If the result is not as specified, replace the heated oxygen sensor.
- Measure the resistance according to the value(s) in the table below.