How To Proceed With Troubleshooting [08/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  DIAGNOSIS SYSTEM [08/2015 - 08/2017]  , or refer to  DIAGNOSIS SYSTEM [08/2017 - 08/2019]  , or refer to  DIAGNOSIS SYSTEM [08/2019 - ] 

Result: 

A 

See step  4

1. Refer to the problem symptoms table.

   Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2017] , or refer to PROBLEM SYMPTOMS TABLE [08/2017 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  6

Result: 

A 

See step  5

1. Operation Check

   Refer to OPERATION CHECK [08/2015 - 08/2017] , or refer to OPERATION CHECK [08/2017 - ] 

2. Terminals of ECU

   Refer to TERMINALS OF ECU [08/2015 - 08/2017] , or refer to TERMINALS OF ECU [08/2017 - ] 

3. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2017] , or refer to DATA LIST / ACTIVE TEST [08/2017 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

Result

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

END