How To Proceed With Troubleshooting [08/2015 - ]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result:
NEXT
See step 2
- INSPECT BATTERY VOLTAGE
- Measure the battery voltage with the engine switch off.
Standard voltage
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Measure the battery voltage with the engine switch off.
- CHECK NAVIGATION SYSTEM
- See the navigation system.
See DTC CHECK / CLEAR [08/2015 - 08/2016] , or See DTC CHECK / CLEAR [08/2016 - 08/2017] , or See DTC CHECK / CLEAR [08/2017 - ]
Result
Result Proceed to Navigation system is normal A Navigation system is abnormal B
Result:
B
GO TO NAVIGATION SYSTEM. See HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2016] , or See HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 08/2017] , or See HOW TO PROCEED WITH TROUBLESHOOTING [08/2017 - ]
Result:
A
See step 4
- See the navigation system.
- CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
- Use the Techstream to check if the CAN communication system is functioning normally.
See HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
Result
Result Proceed to CAN DTC is not output A CAN DTC is output B
Result:
B
GO TO CAN COMMUNICATION SYSTEM. See HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
Result:
A
See step 5
- Use the Techstream to check if the CAN communication system is functioning normally.
- CHECK FOR DTC*
- Check for DTCs and note any codes that are output.
- Clear the DTC.
- Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
Result
Result Proceed to DTC is not output A DTC is output B
Result:
B
GO TO DIAGNOSTIC TROUBLE CODE CHART. See DIAGNOSTIC TROUBLE CODE CHART [08/2015 - ]
Result:
A
See step 6
- PROBLEM SYMPTOMS TABLE
- See the Problem Symptoms Table.
See PROBLEM SYMPTOMS TABLE [08/2015 - ]
Result
Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B
Result:
B
ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
Result:
A
See step 7
- See the Problem Symptoms Table.
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Data List / Active Test.
- Terminals of ECU.
See TERMINALS OF ECU [08/2015 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 8
- ADJUST, REPAIR OR REPLACE
Result
Proceed to NEXT Result:
NEXT
See step 9
- CONFIRMATION TEST
Result
Proceed to NEXT Result:
NEXT
END