Installation [08/2015 - ]: Procedure

INSTALL CRUISE CONTROL MAIN SWITCH
1. Connect the connector to install the cruise control main switch wire.
2. Install the cruise control main switch with the 2 screws.
  Torque: 2.4 N*m (24 kgf*cm, 22 in.*lbf)
3. Connect the connector.
INSTALL STEERING PAD
(Refer to INSTALLATION [08/2015 - ] )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2017] Refer to INITIALIZATION [08/2017 - ] ).
CHECK SRS WARNING LIGHT
(Refer to DIAGNOSIS SYSTEM [08/2015 - ] )