How To Proceed With Troubleshooting [08/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. See  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] 

Result: 

A 

See step  4

1. Check the indicator.

   See DIAGNOSIS SYSTEM [08/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Check for DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

2. Clear the DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

3. Recheck for DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO DTC CHART. See  DIAGNOSTIC TROUBLE CODE CHART [08/2015 - ]  

Result: 

A 

See step  6

1. See the Problem Symptoms Table.

   See PROBLEM SYMPTOMS TABLE [08/2015 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  8

Result: 

A 

See step  7

1. Terminals of ECU.

   See TERMINALS OF ECM [08/2015 - ] 

2. Data List / Active Test.

   See DATA LIST / ACTIVE TEST [08/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

END