Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2021 >> C-HR LE >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control / Dynamic Control Systems - Service Information >> Brake Hold Switch >> Inspection [02/2017 - ] >> Procedure

Inspection [02/2017 - ]: Procedure

  1. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY771119Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Brake Hold Switch (Electric Parking Brake Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        12 (+B) - 8 (E) Switch pushed Below 1 Ω
        12 (+B) - 8 (E) Switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the brake hold switch (electric parking brake switch assembly).

scientia non olet · About Mike's Workshop Manuals