Door Glass Other Than Driver's Door Cannot Be Operated Using Power Window Main Switch (Can Be Operated Using Subswitches): Procedure

1. Switch the ignition off.
2. Disconnect the negative battery cable.

   Refer to REMOVAL

3. Disconnect the power window master switch connector.
4. Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
5. Is the connector normal?

   Result

   Result
   Yes
   No

Result:  2

No 

See step  8

Result:  1

Yes 

See step  2

1. Disconnect the power window switch connector.
2. Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
3. Is the connector normal?

   Result

   Result
   Yes
   No

Result:  2

No 

See step  7

Result:  1

Yes 

See step  3

1. Reconnect all the disconnected connectors.
2. Connect the negative battery cable.

   Refer to INSTALLATION

3. Measure the voltage at the following power window master switch terminals (vehicle wiring harness).

   Refer to INSPECTION

   • Terminals F3-7 and F3-8 if door glass (RF) does not operate
   • Terminals F3-4 and F3-5 if door glass (LR) does not operate
   • Terminals F3-1 and F3-2 if door glass (RR) does not operate
4. Is the power window master switch normal?

   Result

   Result
   Yes
   No

Result:  1

Yes 

See step  5

Result:  2

No 

See step  6

1. Does the power window system operate normally?

   Result

   Result
   Yes
   No

Result:  1

Yes 

TROUBLESHOOTING COMPLETED. (EXPLAIN THE PROBLEM TO THE CUSTOMER.) 

Result:  2

No 

VERIFY THE MALFUNCTION SYMPTOM IN THE SYMPTOM TROUBLESHOOTING CHART AND PERFORM THE OTHER APPLICABLE MALFUNCTION DIAGNOSIS. 

• Power window master switch terminal F3-8 and front passenger side power window switch (RF) terminal F6-5
• Power window master switch terminal F3-7 and front passenger side power window switch (RF) terminal F6-2
• Power window master switch terminal F3-5 and rear power window switch (LR) terminal F7-5
• Power window master switch terminal F3-4 and rear power window switch (LR) terminal F7-2
• Power window master switch terminal F3-2 and rear power window switch (RR) terminal F8-5
• Power window master switch terminal F3-1 and rear power window switch (RR) terminal F8-2

If there is a common connector: 

• Inspect the common connector and terminals for corrosion, damage, or disconnection and the common wiring harnesses for an open or short circuit to determine the malfunctioning location.
• Repair or replace the malfunctioning location.

If there is no common connector: 

• Repair or replace the wiring harness which has an open or short circuit.

1. Go to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

1. Refer to REMOVAL

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

Result

Result:  1

NEXT 

See step  4

Result

Result:  1

NEXT 

See step  4