How To Proceed With Troubleshooting [11/2017 - ]: Procedure

Result

Result: 

NEXT 

See step  2

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

Result

Result: 

NEXT 

See step  4

1. Refer to DTC Check/Clear procedures of the audio and visual system.

   Refer to DTC CHECK / CLEAR [11/2017 - ]

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO AUDIO AND VISUAL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - ] 

Result: 

A 

See step  5

Result

Result: 

B 

See step  7

Result: 

A 

See step  6

Result

Result: 

NEXT 

See step  7

1. Refer to the audio and visual system.

   Refer to PROBLEM SYMPTOMS TABLE [11/2017 - 08/2018] Refer to PROBLEM SYMPTOMS TABLE [08/2018 - ]

   Result

   Result	Proceed to
   Symptom does not appear	A
   Symptom appears	B

Result: 

B 

FOLLOW THE AUDIO AND VISUAL SYMPTOM CHART TO PERFORM TROUBLESHOOTING 

Result: 

A 

See step  8

1. Refer to the Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [11/2017 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  9

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [11/2017 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  10

Result

Result: 

NEXT 

See step  11

Result

Result: 

NEXT 

END