How To Proceed With Troubleshooting [12/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2015 - 08/2016]  Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017]  Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - ] 

Result: 

A 

See step  4

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [12/2015 - ] 

2. Clear the DTCs.
3. Recheck for DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2015 - 08/2016]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2016 - 11/2017]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2017 - ]  

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [12/2015 - 08/2016] Refer to PROBLEM SYMPTOMS TABLE [08/2016 - 11/2017] Refer to PROBLEM SYMPTOMS TABLE [11/2017 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECM.

   Refer to TERMINALS OF ECM [12/2015 - 08/2016] Refer to TERMINALS OF ECM [08/2016 - ] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [12/2015 - 08/2016] Refer to DATA LIST / ACTIVE TEST [08/2016 - 11/2017] Refer to DATA LIST / ACTIVE TEST [11/2017 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END