Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2017 >> Prius Prime Advanced >> Repair and Diagnosis >> Electrical >> Starter >> Starting System Power Switch - Service Information >> Power Switch >> Inspection [09/2016 - ] >> Procedure

Inspection [09/2016 - ]: Procedure

  1. INSPECT POWER SWITCH 
    1. Measure the resistance according to the value(s) in the table below.
      GTY566689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Power Switch)

      Standard Resistance

      Tester Connection Condition Specified Condition
      5 (SS1) - 6 (AGND)
      1 (SS2) - 6 (AGND)      		 Not pushed 10 kΩ or higher
      Pushed Below 1 Ω

      If the result is not as specified, replace the power switch.

    2. Apply auxiliary battery voltage between the terminals of the power switch, and check the illumination condition of the power switch indicator light.

      OK

      Condition Specified Condition
      Auxiliary battery positive (+) → Terminal 9 (SWIL)
      Auxiliary battery negative (-) → Terminal 6 (AGND)      		 Illuminates

      HINT: 

      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the power switch indicator light will not illuminate.
      • If the voltage is too low, the power switch indicator light will not illuminate.

      If the result is not as specified, replace the power switch.

scientia non olet · About Mike's Workshop Manuals