Installation [09/2016 - ]: Procedure

INSTALL BATTERY STATE SENSOR ASSEMBLY
1. Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder.
2. Install the battery state sensor assembly to the auxiliary battery and tighten the nut.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
3. Connect the engine wire to the battery state sensor assembly with the nut.
  Torque: 7.6 N*m (77 kgf*cm, 67 in.*lbf)
  
  NOTE:
  When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
  
  Refer to INITIALIZATION [09/2016 - 05/2019] , or refer to INITIALIZATION [05/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ]
4. Connect the battery state sensor assembly connector.
5. Engage the 2 claws to connect the wire harness to the battery current sensor holder.