Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2017 >> Prius C Two >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Pre-Collision System - Diagnostics - Introduction >> Pre-Collision System >> Utility [11/2015 - ] >> Utility [11/2015 - ]

Utility [11/2015 - ]

NOTE:
  • If "Pre-collision City Sensor Learning" are not performed, all systems using the pre-collision city sensor may be affected.
  • If the pre-collision city sensor has been replaced, or the windshield glass has been replaced or removed/installed, be sure to perform Pre-collision City Sensor Learning (Refer to ADJUSTMENT [11/2015 - ] ).
  • When replacing the windshield glass of a vehicle equipped with a pre-collision city sensor, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the pre-collision city sensor may not be able to be installed due to a missing bracket or the pre-collision system may not operate properly due to a difference in the transmissivity or black ceramic border.

HINT: 

The pre-collision city sensor recognizes the white lines in relation to the vehicle on the basis of coordinates derived from the traveling direction of the vehicle. These coordinates differ for each vehicle depending on the tolerance and installation position of the pre-collision city sensor. Therefore, pre-collision city sensor optical axis learning must be performed individually for each vehicle.

  1. Recognition Camera/Target Position Memory 
    1. Before performing "Recognition Camera Axis Adjust", store the recognition camera position information, target position information and vehicle information in the pre-collision city sensor.

      HINT: 

      For pre-collision city sensor adjustment procedures (Refer to ADJUSTMENT [11/2015 - ] ).

  2. Recognition Camera Axis Adjust 
    1. After performing Recognition Camera/Target Position Memory, further calibrate the stored data.

      HINT: 

      • Since there is a margin of error in the internal data derived from the stored pre-collision city sensor position (horizontal and vertical coordinates, etc.), calibrating the internal data stored in the pre-collision city sensor improves the recognition sensitivity of the pre-collision city sensor.
      • For pre-collision city sensor adjustment procedures (Refer to ADJUSTMENT [11/2015 - ] ).
  3. Control Mode 
    1. When reproducing problem symptoms of the pre-collision system, do not attempt to operate the pre-collision brake control, only operate the pre-collision alarm control.

      HINT: 

      When reproducing problem symptoms of the pre-collision system, actually operating the pre-collision brake control would be dangerous. To avoid this, when triggering operation of the pre-collision system, do not operate the pre-collision brake control, only operate the pre-collision alarm control.

  4. PCS Image Record Setting 
    1. PCS image recording can be enabled or disabled. When enabled, images will be stored in the pre-collision city sensor.

      HINT: 

      • When PCS image recording is enabled, images are stored when the pre-collision brake control operates.
      • The stored images cannot be viewed.
  5. PCS Image Information Clear 
    1. If it is necessary to clear the images stored in the pre-collision city sensor, use this utility.
  6. History Clear 
    1. If the history data status is "Yes", clear the history.
scientia non olet · About Mike's Workshop Manuals