How To Proceed With Troubleshooting [11/2015 - ]: Procedure

Result

NEXT 

See step  2

1. Measure the auxiliary battery voltage with the ignition switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output (w/o Toyota Safety Sense C)	B
   CAN DTC is output (w/ Toyota Safety Sense C)	C

Result: 

B 

REFER TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2015 - ] )

Result: 

C 

REFER TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2015 - ] )

Result: 

A 

See step  4

Refer to DTC Check / Clear DTC CHECK / CLEAR [11/2015 - ] ).

1. Check for DTCs and note any codes that are output.
2. Clear the DTCs.
3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

   Result

   Result	Proceed to
   DTC does not reoccur	A
   DTC reoccurs	B

Result: 

B 

REFER TO DTC CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2015 - ] )

Result: 

A 

See step  5

Refer to Problem Symptoms Table PROBLEM SYMPTOMS TABLE [11/2015 - ] ).

Result

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECU TERMINALS OF ECU [11/2015 - ] ).
2. Data List / Active Test DATA LIST / ACTIVE TEST [11/2015 - ] ).

   Result

   Proceed to
   NEXT

NEXT 

See step  7

Result

NEXT 

See step  8

Result

NEXT 

END