Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2017 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Pre-Collision System Cancel Switch (Service Information) (Except Hybrid) >> Pre-Collision System Cancel Switch >> Inspection [12/2013 - 11/2016] >> Procedure

Inspection [12/2013 - 11/2016]: Procedure

  1. INSPECT PRE-COLLISION SYSTEM CANCEL SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY434712Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Pre-collision System Cancel Switch Assembly)

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      1 - 2 Pressed Below 1 Ω
      1 - 2 Not pressed 10 kΩ or higher

      If the result is not as specified, replace the pre-collision system cancel switch assembly.

scientia non olet · About Mike's Workshop Manuals