Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2017 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 86 (Hybrid Battery Control System (Service Information)) >> Combination Switch >> Installation [02/2014 - ] >> Procedure

Installation [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL EV DRIVE MODE SWITCH (PATTERN SELECT SWITCH ASSEMBLY) 
    1. Engage the 2 claws and install the EV drive mode switch (pattern select switch assembly) to the No. 2 switch hole base.
  2. INSTALL NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 20

  3. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  4. INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 5

  5. INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 6

  6. INSTALL FRONT PANEL GARNISH RH 

    Refer to PROCEDURE - Step 7

  7. INSTALL FRONT PANEL GARNISH LH 

    Refer to PROCEDURE - Step 8

  8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

scientia non olet · About Mike's Workshop Manuals