Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2017 >> 86 Base, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel System (Service Information) >> Fuel Pressure Sensor >> Installation [06/2016 - ] >> Procedure

Installation [06/2016 - ]: Procedure

  1. INSTALL FUEL INJECTOR ASSEMBLY 
    NOTE:

    Be sure to use a new fuel delivery pipe and new fuel pressure sensor. (See step  2)

  2. INSTALL FUEL DELIVERY PIPE (for Bank 1) 
    1. Install the fuel delivery pipe (for Bank 1) with the 2 bolts.

      Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

  3. INSTALL FUEL PRESSURE SENSOR 
    1. Temporarily install the new fuel pressure sensor by hand as much as possible to the fuel delivery pipe (for Bank 1).
    2. Tighten the fuel pressure sensor.

      Torque: 46 N*m (469 kgf*cm, 34 ft.*lbf) 

      NOTE:
      • Ensure that no oil adheres to the threads of the fuel pressure sensor and No. 1 fuel delivery pipe sub-assembly RH.
      • Do not allow any foreign matter to adhere when installing the fuel pressure sensor.
      • Once the fuel pressure sensor is tightened to the specified torque, do not retighten or recheck it.
    3. Connect the fuel pressure sensor connector and 2 fuel injector connectors.
  4. INSTALL FUEL DELIVERY PIPE 

    See step  5

  5. INSTALL INTAKE MANIFOLD 

    (Refer to INSTALLATION [06/2016 - ] )

scientia non olet · About Mike's Workshop Manuals