How To Proceed With Troubleshooting [03/2017 - ]: Procedure

Result: 

NEXT 

See step  2

1. Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

   HINT: 

   The rear view monitor display may be temporarily distorted due to radio waves around the vehicle.

   Problem Symptom	Cause
   Both of the following conditions are met:  The problem symptom indicates a rear view monitor display malfunction and the problem symptom cannot be reproduced. DTC C1622 is output as "Hist" only.*	The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.

   • *: DTCs output as "Hist" will not be output again after DTCs are cleared.

Result: 

NEXT 

See step  3

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   HINT: 

   If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

Result: 

NEXT 

See step  4

1. Check for DTCs and note any codes that are output.

   Refer to DTC CHECK / CLEAR [03/2017 - ] 

2. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [03/2017 - ] 

3. Recheck for DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [03/2017 - ]  

Result: 

A 

See step  5

Result: 

NEXT 

See step  6

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [03/2017 - ] 

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

Result: 

B 

See step  8

Result: 

A 

See step  7

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [03/2017 - ] 

Result: 

NEXT 

See step  8

Result: 

NEXT 

See step  9

Result: 

NEXT 

END