Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2013 >> Yaris LE, 2D Hatchback >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (Service Information) >> HEATED OXYGEN SENSOR (for Sedan) >> Removal >> Removal

HEATED OXYGEN SENSOR (for Sedan): Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER  . Refer to REMOVAL - Step 2
  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  . Refer to REMOVAL - Step 3
  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) 
  5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 4
  6. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 5
  7. REMOVE CONSOLE BOX CARPET  . Refer to REMOVAL - Step 6
  8. REMOVE REAR CONSOLE BOX ASSEMBLY  . Refer to REMOVAL - Step 7
  9. REMOVE INSTRUMENT PAD LOWER LH  . Refer to REMOVAL - Step 36
  10. REMOVE HEATED OXYGEN SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
    3. Using SST, remove heated oxygen sensor.
      Fig 1: Remove/Install Heated Oxygen Sensor
      GTY329340Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
scientia non olet · About Mike's Workshop Manuals