Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2012 >> Prius V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System [Diagnostic Codes & Circuit Tests] >> SFI System >> DTC P2610: ECM / PCM Internal Engine Off Timer Performance >> Procedure

DTC P2610: ECM / PCM Internal Engine Off Timer Performance: Procedure

  1. REPLACE ECM 
    1. Replace the ECM. Refer to REMOVAL .

    NEXT: Go to next step 

  2. CHECK WHETHER DTC OUTPUT RECURS (DTC P2610) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
    5. Put the engine in inspection mode (maintenance mode). Refer to INSPECTION MODE PROCEDURE .
    6. Start the engine and wait for 10 minutes or more.
    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
    8. If no pending DTC is displayed, the repair has been successfully completed.

    NEXT → END 

scientia non olet · About Mike's Workshop Manuals