Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2012 >> Prius Two >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 90 (Brake Control System (Plug-In) (Service Information)) >> Brake Pedal Stroke Sensor >> Removal >> Removal

Brake Pedal Stroke Sensor: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

  1. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY 

    Refer to REMOVAL

  2. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY 
    1. Remove the 2 nuts and brake pedal stroke sensor assembly.
      Fig 1: Identifying Brake Pedal Stroke Sensor Assembly & Nuts
      GTY336044Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Do not drop the brake pedal stroke sensor assembly.
      • If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.
scientia non olet · About Mike's Workshop Manuals