TC and CG Terminal Circuit: Procedure

1. Disconnect the power management control ECU connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance (Check for Open)

   Tester Connection	Condition	Specified Condition
   L135-11 (TC) - L61-13 (TC)	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - POWER MANAGEMENT CONTROL ECU) 

OK: Go to next step 

Fig 1: Checking L61 Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance (Check for Open)

   Tester Connection	Condition	Specified Condition
   L61-4 (CG) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *1

   DLC3

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - BODY GROUND) 

OK: Go to next step 

Fig 2: Checking L61 Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance (Check for Open)

   Tester Connection	Condition	Specified Condition
   L61-13 (TC) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *1

   DLC3

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU 

OK → See step   4