Fuel Tank Pressure Sensor: Removal: Removal

Refer to REMOVAL 

1. Disconnect the connector.
   Fig 1: Identifying Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the tube joint clip, and pull out the vapor pressure sensor assembly.
   Fig 2: Removing Vapor Pressure Sensor Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *1	Vapor Pressure Sensor Assembly
   *2	O-ring
   *3	Fuel Hose Joint
   *4	Tube Joint Clip
   	Pull

   NOTE:

   • Before this operation, check that there is no dirt or other foreign objects around the vapor pressure sensor assembly. Clean the vapor pressure sensor assembly if necessary.
   • It is necessary to prevent mud or dirt from entering the vapor pressure sensor assembly. If mud or dirt gets in the vapor pressure sensor assembly, the O-ring may not seal properly.
   • Do not use any tools for this operation.
   • If the fuel hose joint and vapor pressure sensor are stuck, carefully try wiggling or pushing and pulling on the vapor pressure sensor to release it. Pull the sensor off the fuel hose joint carefully.