Power Window Master Switch: Inspection: Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
- Check that the LED illuminates.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Apply battery voltage to the multiplex network master switch assembly and check that the LED illuminates.
OK
Measurement Condition Specified Condition Battery positive (+) → 18 (LED)
Battery negative (-) → 12 (GND)LED illuminates TEXT IN ILLUSTRATION*1 Component without harness connected
(to Multiplex Network Master Switch Assembly)If the result is not as specified, replace the multiplex network master switch assembly.
- Apply battery voltage to the multiplex network master switch assembly and check that the LED illuminates.
- Check that the LED illuminates.