Rear Power Window Switch: Inspection: Inspection

WARNING: This page is about a different car, the 2011 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT REAR POWER WINDOW SWITCH ASSEMBLY

for Rear LH Side:

Measure the resistance when the switch is operated according to the value(s) in the table below.

Fig 1: Identifying Rear LH Side Power Window Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
1 (D) - 2 (SD) 3 (B) - 4 (U)	UP	Below 1 Ω
1 (D) - 2 (SD) 4 (U) - 5 (SU)	OFF	Below 1 Ω
2 (SD) - 3 (B) 4 (U) - 5 (SU)	DOWN	Below 1 Ω

If the result is not specified, replace the rear power window switch assembly.

for Rear RH Side:

Measure the resistance when the switch is operated according to the value(s) in the table below.

Fig 2: Identifying Rear RH Side Power Window Switch Connector Terminals

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
1 (D) - 2 (SD) 3 (B) - 4 (U)	UP	Below 1 Ω
1 (D) - 2 (SD) 4 (U) - 5 (SU)	OFF	Below 1 Ω
2 (SD) - 3 (B) 4 (U) - 5 (SU)	DOWN	Below 1 Ω

If the result is not specified, replace the rear power window switch assembly.