Slip Indicator Light does not Come ON: Procedure
WARNING: This page is about a different car, the 2012 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CAN COMMUNICATION SYSTEM
- Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM
.
Result
Result Proceed to DTC is not output A DTC is output B
B → See step 4
A: Go to next step
- Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM
.
- PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Select Active Test mode on the Techstream. Refer to DATA LIST / ACTIVE TEST
.ABS/VSC/TRAC
Tester Display Test Part Control Range Diagnostic Note Slip Indicator Light Slip indicator light Indicator light ON/OFF Observe combination meter - Check that the slip indicator light turns on or off in accordance with the Techstream operation.
OK
The slip indicator light turns on or off in accordance with the Techstream operation.
HINT:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part. Refer to PROBLEM SYMPTOMS TABLE .
NG → See step 3
OK → See step 5
- INSPECT COMBINATION METER ASSEMBLY
- Turn the ignition switch off.
- Perform the Active Test of the combination meter (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST .
- Check the combination meter.
OK
The slip indicator light turns on or off in accordance with the Techstream operation.
HINT:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE .
NG → See step 6
OK → See step 5
- INSPECT CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
- REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to REMOVAL
- REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL