Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2012 >> FJ Cruiser 4WD, Automatic T/Case Control >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Brake Control System (Service Information)) >> Yaw Rate And Acceleration Sensor >> Installation >> Installation

Yaw Rate And Acceleration Sensor: Installation: Installation

WARNING: This page is about a different car, the 2012 Lexus GX 460. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL YAW RATE AND ACCELERATION SENSOR 
    1. Attach the clamp to the hole of the sensor bracket.
    2. Connect the connector.
      NOTE:

      Securely connect the connector.

    3. Install the yaw rate and acceleration sensor with the 2 bolts.

      Torque: 15 N*m (148 kgf*cm, 11 ft.*lbf) 

      NOTE:
      • If the sensor is dropped, replace it.
      • Make sure the bracket rotation stopper touches the installation position.
      • Make sure that the sensor is oriented correctly.
      • When installing the sensor, make sure to avoid impacts to the sensor.
  2. INSTALL REAR CONSOLE BOX ASSEMBLY 
    1. w/ Refrigerated Cool Box:

      Install the rear console box assembly. Refer to INSTALLATION .

    2. w/o Refrigerated Cool Box:

      Install the rear console box assembly. Refer to INSTALLATION .

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  4. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION 
    1. Perform yaw rate and acceleration sensor zero point calibration. Refer to CALIBRATION .
  5. CHECK YAW RATE AND ACCELERATION SENSOR SIGNAL 
    1. Check the yaw rate and acceleration sensor signal. Refer to TEST MODE PROCEDURE .
scientia non olet · About Mike's Workshop Manuals