Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2012 >> FJ Cruiser 4WD, Automatic T/Case Control >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Service Information) >> Accelerator Pedal >> On-Vehicle Inspection >> On-Vehicle Inspection

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL ROD ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. Read the value displayed on the Techstream.

      Standard Voltage

      Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
      Released 0.5 to 1.1 V 1.2 to 2.0 V
      Depressed 2.6 to 4.5 V 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal, wire harness or ECM.

scientia non olet · About Mike's Workshop Manuals