Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2011 >> Sienna XLE, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System (Diagnostics - Introduction) >> Cruise Control System >> Fail-Safe Chart >> Fail-Safe Chart

Fail-Safe Chart

HINT: 

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition Auto Cancel Condition Re-operation Condition
Cruise main indicator light blinks
  • There is open or short in stop light switch circuit
  • There is problem with vehicle speed signal
 Turn cruise control main switch on again
Cruise main indicator light blinks
  • There is problem with input circuit of stop light switch
  • There is problem with cancel circuit
  • Turn ignition switch off then on again
  • Turn cruise control main switch on again
Cruise main indicator light remains on Under the following conditions, the stored vehicle speed is maintained:
  • Vehicle speed is lower than low speed limit (approx. 40 km/h (25 mph)) while driving with cruise control on
  • VSC system is operated
 Push cruise control main switch to + RES
  • Vehicle speed is lower than stored speed by approx. 16 km/h (10 mph) or more
 Push cruise control main switch to - SET
Cruise indicator light goes off
  • There is problem with throttle position sensor and motor
 Turn cruise control main switch on again
scientia non olet · About Mike's Workshop Manuals