Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2011 >> FJ Cruiser 4WD, Part Time >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Register Transmitter ID

Register Transmitter ID

  1. Set the pressure of all tires (including spare tire) to the pressure specified on the tire and loading information label.
  2. Turn ignition switch OFF.
  3. Connect a Techstream to the DLC3.
  4. Turn ignition switch ON.
  5. Turn Techstream ON.
  6. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
  7. Follow the procedures displayed on the screen.
  8. Confirm the ID numbers for all tires (including the spare tire) are displayed on the screen.
NOTE:
  • It may take up to about 2 or 3 minutes to update the tire pressure data. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25.
  • If the IDs have not been registered, DTC C2171/71 is set in the tire pressure warning ECU after 3 minutes or more.
  • If normal pressure values are displayed, the IDs have been registered correctly.
  • If the tire pressure values are not displayed after a few minutes, the IDs may be incorrect or the system may have a malfunction.
  • After all IDs are registered, DTC C2126/26 (Transmitter ID not Received in Main Mode) is set in the tire pressure warning ECU and the tire pressure warning light blinks for 1 minute and then stays on. When the tire pressure warning ECU successfully receives radio waves from all the transmitters whose IDs are stored in the ECU, DTC C2126/26 is deleted and the tire pressure warning light goes off.
scientia non olet · About Mike's Workshop Manuals