DTC P0101: Mass Air Flow Circuit Range / Performance Problem: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101)
- Connect a Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read DTCs.
Result
Display (DTC Output) Proceed To P0101 A P0101 and other DTCs B HINT:
If any DTCs other than P0101 are output, troubleshoot those DTCs first.
B → See step 4
A: Go to next step
- CHECK AIR INDUCTION SYSTEM
- Check the air induction system for vacuum leakage. Refer to ON-VEHICLE INSPECTION - Step 2
.
OK
No leakage from air induction system.
NG → REPAIR OR REPLACE AIR INDUCTION SYSTEM
OK: Go to next step
- Check the air induction system for vacuum leakage. Refer to ON-VEHICLE INSPECTION - Step 2
.
- CHECK PCV HOSE CONNECTIONS
OK
PCV hose is connected correctly and is not damaged.
NG → REPAIR OR REPLACE PCV HOSE
OK → See step 5
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE MASS AIR FLOW METER. Refer to REMOVAL