Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2010 >> Yaris 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (Service Information) >> Camshaft Position Sensor >> Inspection >> Inspection

Camshaft Position Sensor: Inspection: Inspection

  1. INSPECT CAMSHAFT POSITION SENSOR 
    Fig 1: Identifying Resistance Between Terminals
    GTY237189Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Check the resistance.
      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance

        Temperature Specified Condition
        Cold 1,630 to 2,740 Ω
        Hot 2,065 to 3,225 Ω

        HINT: 

        In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50 °C (14 to 122 °F). Hot means approximately 50 to 100 °C (122 to 212 °F).

        If the resistance is not as specified, replace the camshaft position sensor.

scientia non olet · About Mike's Workshop Manuals