Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2010 >> Venza 3.5 K, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FE) (Service Information) >> Camshaft Position Sensor >> Removal >> Removal

Camshaft Position Sensor: Removal: Removal

  1. REMOVE NO. 1 ENGINE UNDER COVER 
  2. REMOVE NO. 2 ENGINE UNDER COVER 
  3. DRAIN ENGINE COOLANT  . Refer to REPLACEMENT - Step 4
  4. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY 
    1. Remove the windshield wiper motor and link assembly. Refer to REMOVAL .
  5. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY  . Refer to REMOVAL - Step 10
  6. REMOVE COOL AIR INTAKE DUCT SEAL  . Refer to REMOVAL - Step 18
  7. REMOVE V-BANK COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 19
  8. REMOVE AIR CLEANER CAP WITH HOSE  See step  5
  9. REMOVE INTAKE AIR SURGE TANK ASSEMBLY  . Refer to REMOVAL - Step 16
  10. REMOVE VVT SENSOR 
    1. Disconnect the 4 sensor connectors.
    2. Remove the 4 bolts and 4 sensors.
      Fig 1: Locating VVT Sensor Connectors And Bolts
      GTY251158Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals