Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2010 >> Sienna LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System (Service Information)) >> VVT Sensor >> Removal >> Removal

VVT Sensor: Removal: Removal

WARNING: This page is about a different car, the 2010 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE V-BANK COVER  . Refer toREMOVAL - Step 3
  2. REMOVE AIR CLEANER HOSE ASSEMBLY  . Refer toREMOVAL - Step 4
  3. REMOVE VVT SENSOR (for Intake Side of Bank 1) 
    1. Disconnect the sensor connector.
      Fig 1: Identifying VVT Sensor (For Intake Side of Bank 1) Connector & Bolt
      GTY187835Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and sensor.
  4. REMOVE VVT SENSOR (for Exhaust Side of Bank 1) 
    1. Disconnect the sensor connector.
      Fig 2: Identifying VVT Sensor (For Exhaust Side of Bank 1) Connector & Bolt
      GTY173078Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and sensor.
  5. REMOVE VVT SENSOR (for Intake Side of Bank 2) 
    1. Disconnect the sensor connector.
      Fig 3: Identifying VVT Sensor (For Intake Side of Bank 2) Connector & Bolt
      GTY173080Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and sensor.
  6. REMOVE VVT SENSOR (For Exhaust Side of Bank 2) 
    1. Disconnect the sensor connector.
      Fig 4: Identifying VVT SENSOR (For Exhaust Side of Bank 2) Connector & Bolt
      GTY173100Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and sensor.
scientia non olet · About Mike's Workshop Manuals