Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2010 >> Prius PHV >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Cruise Control System (Service Information)) >> Cruise Control Main Switch >> Inspection >> Inspection

Cruise Control Main Switch: Inspection: Inspection

WARNING: This page is about a different car, the 2010 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT CRUISE CONTROL MAIN SWITCH 
    Fig 1: Inspecting Cruise Control Main Switch
    GTY207055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard resistance

      Tester Connection Switch Condition Specified Condition
      1(ECC) - 3(CCS) Neutral 10 kΩ or higher
      1(ECC) - 3(CCS) +/RES 216 to 264 Ω
      1(ECC) - 3(CCS) -/SET 567 to 693 Ω
      1(ECC) - 3(CCS) CANCEL 1,386 to 1,694 Ω
      1(ECC) - 3(CCS) Main Switch off 10 kΩ or higher
      1(ECC) - 3(CCS) Main Switch on Below 1 Ω

      If the result is not as specified, replace the cruise control main switch.

scientia non olet · About Mike's Workshop Manuals