Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2010 >> Prius PHV >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System (Service Information)) >> Knock Sensor >> Removal >> Removal

Knock Sensor: Removal: Removal

WARNING: This page is about a different car, the 2010 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE CYLINDER HEAD SUB-ASSEMBLY (for Bank 1) 
    1. Remove the cylinder head. Refer toREMOVAL .
  2. REMOVE NO. 1 WATER OUTLET PIPE 
    1. Disconnect the 4 wire harness clamps.
      Fig 1: Identifying No. 1 Water Outlet Pipe, Wire Harness Clamps, Nuts & Bolts
      GTY167420Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts, bolt and No. 1 water outlet pipe.
  3. REMOVE KNOCK SENSOR 
    1. Disconnect the 2 sensor connectors.
      Fig 2: Identifying Knock Sensors Connectors & Bolts
      GTY191273Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and 2 sensors.
scientia non olet · About Mike's Workshop Manuals