Distance Control ECU Power Source Circuit: Procedure

1. Disconnect the distance control ECU connector.
   Fig 1: Identifying A20 Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Condition	Specified Condition
   A20-1 (B) - Body ground	Ignition switch on (IG)	10 to 14 V

3. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   A20-10 (SGND) - Body ground	Always	Below 1 Ω
   A20-12 (GND) - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → PROCEED TO NEXT SUSPECTED AREA SHOWN IN  PROBLEM SYMPTOMS TABLE  PROBLEM SYMPTOMS TABLE