Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Venza 2.7 E, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (1AR-FE) - System Testing, Removal & Installation >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

  1. REMOVE FRONT FENDER APRON SEAL RH  (See REMOVAL )
  2. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      Fig 1: Locating Bolt And Sensor
      G05997198Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals