REAR SPEED SENSOR (for AWD): Installation

HINT:

• Use the same procedure for the LH side and RH side.
• The following procedure is for the LH side.
• If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly.

1. INSTALL REAR SPEED SENSOR 
   1. Install the rear speed sensor with the bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      NOTE:

      • Keep the rear speed sensor tip and sensor installation hole free from foreign matter.
        Fig 1: Locating Rear Speed Sensor Bolt

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the No. 1 clamp and No. 2 clamp with the 2 bolts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

      NOTE: Do not twist the rear speed sensor wire when installing the clamps.

      Text in Illustration 

      ILLUSTRATION LEGEND
      
      

      *1	No. 2 Clamp
      *2	No. 1 Clamp

      Fig 2: Locating No. 1 Clamp And No. 2 Clamp Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel well.
      NOTE: Make sure that the grommet's band clamp remains on the outside of the vehicle.
   4. Hold the grommet and pull it from the inside to the outside of the vehicle. Then secure it in place so that it is not tilted.
      NOTE: When pulling out the grommet, do not grip the sensor wire.
   5. Connect the rear speed sensor connector.

      Text in Illustration 

      ILLUSTRATION LEGEND
      
      

      *1

      Grommet

      Fig 3: Locating Rear Speed Sensor

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH  (See INSTALLATION )
3. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH  (See INSTALLATION )
4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY  (See INSTALLATION )
5. INSTALL RECLINING REMOTE CONTROL BEZEL LH  (See INSTALLATION )
6. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
7. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY  (See INSTALLATION )
8. INSTALL NO. 1 DECK BOARD  (See INSTALLATION )
9. INSTALL DECK SIDE TRIM BOX RH  (See INSTALLATION )
10. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
11. INSTALL DECK SIDE TRIM BOX LH  (See INSTALLATION )
12. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
13. INSTALL DECK BOARD ASSEMBLY  (See INSTALLATION )
14. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)  (See INSTALLATION )
15. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
16. INSTALL REAR DOOR SCUFF PLATE LH  (See INSTALLATION )
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
18. CHECK FOR SPEED SENSOR SIGNAL 

    HINT:

    (See TEST MODE PROCEDURE  ).