Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Tundra Base, 5.7 W >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Cruise Control System) >> Distance Control Ecu >> Removal

Distance Control Ecu: Removal

WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  2. REMOVE COWL SIDE TRIM BOARD LH  (See REMOVAL )
  3. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See REMOVAL )
  4. REMOVE INSTRUMENT SIDE PANEL LH  (See REMOVAL )
  5. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH  (See REMOVAL )
  7. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT  (See REMOVAL )
  8. SEPARATE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)  (See REMOVAL )
  9. REMOVE DISTANCE CONTROL ECU ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the bolt and the distance control ECU.
      Fig 1: Locating Distance Control ECU And Bolts
      G05647314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals