Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Tundra Base, 5.7 W >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Control System (2TR-FE)) >> Camshaft Position Sensor >> Inspection

Camshaft Position Sensor: Inspection

WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT CAMSHAFT POSITION SENSOR 
    1. Check the resistance.
      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard 

        TESTER CONNECTIONS SPECIFIED CONDITIONS CHART

        Tester Connection Specified Condition
        1 (G+) - 2 (G-) 835 to 1,400 flat COLD
        1 (G+) - 2 (G-) 1,060 to 1,645 Ω at HOT
        Fig 1: Identifying Camshaft Position Sensor Connector
        G05198394Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        HINT:

        Cold and Hot mean the temperature of the coils themselves. Cold is from -10 to 50°C (14 to 122°F) and Hot is from 50 to 100°C (122 to 212°F).

        If the result is not as specified, replace the camshaft position sensor.

scientia non olet · About Mike's Workshop Manuals