Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CD
1. Check the CD.
  OK: The CD is clean.
  
  HINT:
  
  If dirt is on the CD surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
  
  NOTE: Do not use a conventional record cleaner or antistatic preservative.
NG: CLEAN CD

Fig 1: Cleaning Disc
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to next step
CHECK CD
1. Check that the CD is not deformed or cracked.
  OK: No deformation or cracks on the CD.
NG: CHANGE DISC

Fig 2: Precaution For Disc
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to next step
CHECK OPERATION USING ANOTHER CD
1. Check if the problem recurs using another CD.
  OK: The problem does not occur.
NG: Go to step 4

OK: END
CHECK RADIO RECEIVER ASSEMBLY
1. Check that the radio receiver assembly is properly installed.
  OK: Radio receiver assembly is properly installed.
NG: REINSTALL RADIO RECEIVER ASSEMBLY PROPERLY

OK: REPLACE RADIO RECEIVER ASSEMBLY (See REMOVAL )