Accelerator Pedal: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL ACCELERATOR PEDAL ROD ASSEMBLY
NOTE:
- Avoid any physical impact to the accelerator pedal assembly.
- Do not disassemble the accelerator pedal assembly.
1. Install the accelerator pedal with the 2 bolts.
  Torque: 5 N*m (51 kgf*cm, 44 in.*lbf)
2. Connect the accelerator position sensor connector.
  
  Fig 1: Locating Bolts And Accelerator Pedal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)