Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Tacoma X-Runner >> Repair and Diagnosis >> Engine Performance >> Engine Control System (1GR-FE) >> SFI System >> DTC P0630 VIN not Programmed or Mismatch - ECM/PCM >> Inspection Procedure

Inspection Procedure

  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON and turn the Techstream on.
    3. Enter the following menus: Powertrain/Engine and ECT/Trouble Codes.
    4. Read DTCs.

      Result 

      RESULT REFERENCE

      Result Proceed to
      P0630 A
      P0630 and other DTCs B

      If any DTCs other than P0630 are output, troubleshoot those DTCs first.

      NOTE: If P0630 is set, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when inputting the VIN. If DTCs other than P0630 are set, check them first.

      B:  GO TO DTC CHART 

      A: Go to Next Step 

  2. INPUT VIN WITH TECHSTREAM 
    1. Refer to REGISTRATION  .

      NEXT: END 

scientia non olet · About Mike's Workshop Manuals