Inspection Procedure

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

After the inspection is completed, clear the DTCs.

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
1. Enter the "Navigation Check" mode (Vehicle Sensors) (See OPERATION CHECK ).
2. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.
  OK: The readings are almost equal.
NG: Go to step 2

Fig 1: Screen Display - Navigation Check
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPLACE NAVIGATION RECEIVER ASSEMBLY (See REMOVAL )
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Refer to "Speed signal does not change in the navigation check mode" in the Problem Symptoms Table (See PROBLEM SYMPTOMS TABLE ).

NEXT: END