Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> Sienna LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Navigation / Multi-Info Display) >> Navigation Receiver >> Installation

Navigation Receiver: Installation

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NAVIGATION RECEIVER ASSEMBLY 
    Fig 1: Locating No. 1 Radio Bracket And Screws
    G06010784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 RADIO BRACKET 
    1. Install the No. 1 radio bracket with the 4 screws.
    Fig 2: Locating No. 1 Radio Bracket With Screws
    G06010784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL NO. 2 RADIO BRACKET 
    1. Install the No. 2 radio bracket with the 4 screws.
  4. INSTALL NAVIGATION RECEIVER WITH BRACKET 
    1. Connect each connector.
      Fig 3: Locating No. 2 Radio Bracket And Screws
      G06010783Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the navigation receiver with bracket with the 4 bolts.
  5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY  (See INSTALLATION )
  7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
    Fig 4: Locating Navigation Receiver With Bolts
    G06010782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH  (See INSTALLATION )
  10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL RH  (See INSTALLATION )
  11. INSERT MAP DISC 
scientia non olet · About Mike's Workshop Manuals