Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2009 >> RAV4 Base, 3.5 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 658 (Smart Key System (Keyless Entry) (Diagnostics)) >> Smart Key System >> Data List / Active Test >> Data List / Active Test

Data List / Active Test

WARNING: This page is about a different car, the 2010 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / (desired system) / Data List.
    5. According to the display on the Techstream, read the Data List.
      SMART KEY

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D-Door Touch Sensor Driver side door touch sensor / ON or OFF ON: Sensor is touched
      OFF: Sensor is not touched      		 -
      P-Door Touch Sensor Front passenger side door touch sensor / ON or OFF ON: Sensor is touched
      OFF: Sensor is not touched      		 -
      B-Door Touch Sensor Back door touch sensor / ON or OFF ON: Sensor is touched
      OFF: Sensor is not touched      		 -
      D-Door Trigger Switch Driver side outside door handle (lock switch) / ON or OFF ON: Lock switch is pushed
      OFF: Lock switch is not pushed      		 -
      P-Door Trigger Switch Front passenger side door handle (lock switch) / ON or OFF ON: Lock switch is pushed
      OFF: Lock switch is not pushed      		 -
      Tr/B-Door Lock SW Back door lock switch / ON or OFF ON: Back door lock switch is pushed
      OFF: Back door lock switch is not pushed      		 -
      Ignition Switch Ignition switch / ON or OFF ON: Engine switch is on (IG)
      OFF: Engine switch is off      		 -
      Unmatched Vehicle-ID No communication condition between vehicle and electrical key transmitter (vehicle-ID) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      No Response No communication condition between vehicle and electrical key transmitter (response) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      Unmatch Code or Form No communication condition between vehicle and electrical key transmitter (response code and format) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      Key Low Battery Key low battery / Yes or No Yes: Key battery voltage low
      No: Key battery voltage normal      		 -
      Power Save Cnt 10 Min. Power save counter - 10 minutes / Min: 0; Max: 255 Power save counter - 10 minutes -
      Power Save Cnt 5 Days Power save counter - 5 days / Min: 0; Max: 255 Power save counter - 5 days -
      Power Save Cnt 14 Days Power save counter - 14 days / Min: 0; Max: 255 Power save counter - 14 days -
      ACC Switch Ignition switch / ON or OFF ON: Engine switch is on (ACC)
      OFF: Engine switch is off      		 -
      ID Code Difference (Resp) No communication condition between vehicle and electrical key transmitter (ID code) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      C Code Difference No communication condition between vehicle and electrical key transmitter (challenge code) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      Auto Entry Cancel SW Key cancel switch signal/ ON or OFF ON: Key cancel switch is ON
      OFF: Key cancel switch is OFF      		 -
      MAIN BODY

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ACC SW Ignition switch / ON or OFF ON: Engine switch is on (ACC)
      OFF: Engine switch is off      		 -
      IG SW Ignition switch / ON or OFF ON: Engine switch is on (IG)
      OFF: Engine switch is off      		 -
      D Door Courtesy SW Driver side door courtesy light switch signal / ON or OFF ON: Driver side door is open
      OFF: Driver side door is closed      		 -
      P Door Courtesy SW Passenger side door courtesy light switch signal / ON or OFF ON: Passenger side door is open
      OFF: Passenger side door is closed      		 -
      RR Door Courtesy SW Rear right side door courtesy light switch signal / ON or OFF ON: Rear right side door is open
      OFF: Rear right side door is closed      		 -
      RL Door Courtesy SW Rear left side door courtesy light switch signal / ON or OFF ON: Rear left side door is open
      OFF: Rear left side door is closed      		 -
      Back Door Courtesy SW Back door courtesy light switch signal / ON or OFF ON: Back door is open
      OFF: Back door is closed      		 -
      D-Door Lock Pos SW Driver side door lock position switch signal / ON or OFF ON: Driver side door is unlocked
      OFF: Driver side door is closed      		 -
      P-Door Lock Pos SW Passenger side door lock position switch signal / ON or OFF ON: Passenger side door is unlocked
      OFF: Passenger side door is locked      		 -
  2. PERFORM ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Key / Active Test.
    5. According to the display on the Techstream, perform the Active Test.
      SMART KEY

      Tester Display Test Part Control Range Diagnostic Note
      Overhead Tuner Power Supply ON Door control receiver ON or OFF -
      D-Seat Outside Transmitter Driver side electrical key oscillator ON or OFF -
      P-Seat Outside Transmitter Front passenger side electrical key oscillator ON or OFF -
      Fr-Seat Inside Transmitter Indoor electrical key oscillator (front) ON or OFF -
      Inside Trunk/Backdoor Transmitter Indoor electrical key oscillator (rear) ON or OFF -
      Outside Trunk/Backdoor Transmitter Door electrical key oscillator (back door) ON or OFF -
      D-Seat Select Driver side select ON or OFF -
      P-Seat Select Front passenger side select ON or OFF -
      Back Door Select Back door select ON or OFF -
      Wireless Buzzer Operation Wireless door lock buzzer ON or OFF -
      MAIN BODY

      Tester Display Test Part Control Range Diagnostic Note
      Hazard Hazard warning lights ON or OFF -
scientia non olet · About Mike's Workshop Manuals